Engine-Codes - Toyota - P0717 Toyota

P0717 Toyota Code - Input Speed Sensor Circuit No Signal

- Code Popularity: 62,820 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the Code P0717 Toyota?

  • Faulty Transmission Speed Sensor NT (Transmission Revolution Sensor)
  • Transmission Speed Sensor harness is open or shorted
  • Transmission Speed Sensor circuit poor electrical connection
  • Faulty Engine Control Module (ECM)

|How to Fix the P0717 Toyota Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the Cost to Diagnose the Code P0717 Toyota?

Labor: 1.0

The cost to diagnose the P0717 Toyota code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your car have Safety Recalls? → Check here

|What are Code P0717 Toyota Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Possible shifting problems

|What Does the P0717 Toyota Code Mean?

The Input Speed sensor detects the rotation speed of the turbine which indicates the input speed of the transaxle. By comparing the input turbine speed (speed sensor NT) signal with the counter gear speed (speed sensor NC) signal, the Engine Control Module (ECM) detects the shift timing of the gears and appropriately controls the engine torque and hydraulic pressure according to various conditions. As a result, the gears shift smoothly.
The NT terminal of the ECM detects a pulse signal from the speed sensor NT (input RPM). The ECM calculates gear shifts by comparing the signal from speed sensor NT with the signal from speed sensor NC.
While the transaxle is operating in 2nd, 3rd, 4th, 5th, or 6th gear with the shift lever in D, if the input shaft speed is less than 300 rpm although the output shaft speed is more than 1000 rpm, the ECM interprets this as a fault, illuminates the MIL and stores the Diagnostic Trouble Code (DTC).

Input Speed Sensor Circuit No Signal

|Need more Information on the P0717 Toyota Code?

Need more information on how to fix the P0717 Toyota code? Get Access to Factory Service Manuals

|Need Help with the P0717 Toyota Code?

Get the P0717 Toyota code diagnosed by a professional: Find a repair shop in your area