Engine-Codes - Ford - P0622 2010 Ford Fusion

P0622 2010 Ford Fusion Code - Generator Field Terminal Circuit

- Code Popularity: 1,678 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0622 2010 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Battery charge
  • Faulty Generator
  • Generator harness is open or shorted
  • Generator circuit poor electrical connection
  • Engine Control Module (ECM) controlled generator
  • Faulty ECM

Code Tech Notes

If the battery is OK then the alternator is more than likely the problem.

⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P0622 2010 Ford Fusion?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0622 2010 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0622 2010 Ford Fusion code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P0622 2010 Ford Fusion Code Mean?

The Engine Control Module (ECM) uses the generator turn on signal circuit to control the generator. A high side driver within the ECM allows the ECM to turn the generator ON and OFF. When Generator operation is desired, the ECM sends a 5 volt signal to the voltage regulator via the generator turn on signal circuit. This causes the voltage regulator to begin controlling the generator field circuit. Once the Generator is enabled by the ECM, the voltage regulator controls generator output independently of the ECM. Under certain operating conditions, the ECM can turn Off the generator by turning Off the 5 volt signal on the generator turn on signal circuit.
P0622 2010 Ford Fusion Code - Generator Field Terminal Circuit

Need more Information on the Code?

Need more information on how to fix the P0622 2010 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0622 2010 Ford Fusion code diagnosed by a professional: Find a repair shop in your area