P0562 DODGE Possible Causes
- Low battery charge
- Battery defective
- Loose or missing alternator drive belt
- Faulty alternator
- Open or short system voltage circuit
How do I fix code P0562 DODGE
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
P0562 DODGE Tech NotesStart by recharging or replacing the battery.
Cost of diagnosing the P0562 DODGE code
Labor: 1.0The cost of diagnosing the P0562 DODGE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the P0562 DODGE code detected?System voltage falls below 8.5 volts with the engine RPM greater than 2000 RPM for 60 seconds
P0562 DODGE Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Slow engine start
- Low battery power
P0562 DODGE MeaningThe battery supplies electricity to the Engine Control Module (ECM) even when the ignition switch is OFF. This electricity allows the ECM to store data such as Diagnostic Trouble Code (DTC) history, freeze frame data, fuel trim values and other data. If the battery voltage falls below a minimum level, the ECM will conclude that there is a fault in the power supply circuit. The next time the engine starts, the ECM will turn on the Malfunction Indicator Light (MIL) and a DTC will be set.
P0562 DODGE More InformationNeed more information on how to fix the P0562 DODGE code?
Get Access to Factory Service Manuals