Engine-Codes
 
OBDII Code List
 
P0506 2011 NISSAN ROGUE

P0506 2011 NISSAN ROGUE - Idle Speed Control System RPM Lower Than Expected

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What does this mean?

P0506 2011 NISSAN ROGUE Possible Causes

  • Dirty throttle body
  • Electric throttle control actuator misadjusted or damaged
  • Faulty Electric throttle control actuator
  • Electric throttle control actuator harness is open or shorted
  • Electric throttle control actuator circuit poor electrical connection
  • Intake air leak

First diagnose P0506 2011 NISSAN ROGUE code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

P0506 2011 NISSAN ROGUE Tech Notes

If there are no intake leaks, clean throttle body, adjust engine idle and erase engine code. If the code comes back you may have to replace the Electric Throttle Control Actuator (Motor) to repair the problem.

Nissan Rogue Idle Air Volume Relearn

Cost of diagnosing the P0506 2011 NISSAN ROGUE code

    Labor: 1.0

    The cost of diagnosing the P0506 2011 NISSAN ROGUE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

When is the P0506 2011 NISSAN ROGUE code detected?

The idle speed is less than the target idle speed by 100 rpm or more.

P0506 2011 NISSAN ROGUE Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine hard to start
  • Rough or erratic idle speed

P0506 2011 NISSAN ROGUE Meaning

The Engine Control Module (ECM) controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine idling speed. The ECM calculates the actual engine speed from signals of crankshaft position sensor (POS) and camshaft position sensor.

The ECM controls the electric throttle control actuator so that the engine speed coincides with the target value memorized in the ECM. The target engine speed is the lowest speed at which the engine can operate steadily. The optimum value stored in the ECM is determined by taking into consideration various engine conditions, such as during warming up, deceleration, and engine load (air conditioner, power steering and cooling fan operation, etc.)

OBDII Code P0506 2011 NISSAN ROGUE - Idle Speed Control System RPM Lower Than Expected - Engine-Codes.com

P0506 2011 NISSAN ROGUE More Information

Need more information on how to fix the P0506 2011 NISSAN ROGUE code?
Get Access to Factory Service Manuals

Related Information