Engine-Codes - Nissan - P0506 2009 NISSAN ROGUE

P0506 2009 NISSAN ROGUE Code - Idle Speed Control System RPM Lower Than Expected

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|P0506 2009 NISSAN ROGUE code possible causes

  • Dirty throttle body
  • Electric throttle control actuator misadjusted or damaged
  • Faulty Electric throttle control actuator
  • Electric throttle control actuator harness is open or shorted
  • Electric throttle control actuator circuit poor electrical connection
  • Intake air leak

|How is the P0506 2009 NISSAN ROGUE code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|P0506 2009 NISSAN ROGUE code tech notes

If there are no intake leaks, clean throttle body, adjust engine idle and erase engine code. If the code comes back you may have to replace the Electric Throttle Control Actuator (Motor) to repair the problem.

Nissan Rogue Idle Air Volume Relearn

|What is the cost to diagnose the P0506 2009 NISSAN ROGUE code

Labor: 1.0

The cost to diagnose the P0506 2009 NISSAN ROGUE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|When is the P0506 2009 NISSAN ROGUE code detected?

The idle speed is less than the target idle speed by 100 rpm or more.

|What are P0506 2009 NISSAN ROGUE code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine hard to start
  • Rough or erratic idle speed

|What is P0506 2009 NISSAN ROGUE code meaning?

The Engine Control Module (ECM) controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine idling speed. The ECM calculates the actual engine speed from signals of crankshaft position sensor (POS) and camshaft position sensor.
The ECM controls the electric throttle control actuator so that the engine speed coincides with the target value memorized in the ECM. The target engine speed is the lowest speed at which the engine can operate steadily. The optimum value stored in the ECM is determined by taking into consideration various engine conditions, such as during warming up, deceleration, and engine load (air conditioner, power steering and cooling fan operation, etc.)

|Need more information with the P0506 2009 NISSAN ROGUE code?

Need more information on how to fix the P0506 2009 NISSAN ROGUE code?
Get Access to Factory Service Manuals

|Need help with a P0506 2009 NISSAN ROGUE code?

Get the P0506 2009 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area