There is a Factory Service Bulletin for the 1998 Toyota Camry:
1998 Toyota Camry Factory Service Bulletin OBDII Code P0446
Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
The cost to diagnose the P0446 1998 Toyota Camry code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
The Evaporative System (EVAP) canister vent control valve is located on the EVAP canister and is used to seal the canister vent.
This solenoid valve responds to signals from the Engine Control Module (ECM). When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal the canister vent. The ability to seal the vent is necessary for the on board diagnosis of other evaporative emission control system components. This solenoid valve is used only for diagnosis and usually remains open.
The P0446 code is triggered when an improper voltage signal is sent to Engine Control Module through the EVAP canister vent control valve.
Need more information on how to fix the P0446 1998 Toyota Camry code? Get Access to Factory Service Manuals
Get the P0446 1998 Toyota Camry code diagnosed by a professional: Find a repair shop in your area