Engine-Codes - Nissan - P0445 2010 Nissan Rogue

P0445 2010 Nissan Rogue Code - EVAP Canister Purge Volume Control Solenoid Valve Circuit Shorted

- Code Popularity: 2,835 Views
- Repair Importance Level: 1/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0445 2010 Nissan Rogue?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Evaporative Emission (EVAP) Purge Solenoid Control
  • Evaporative Emission (EVAP) Purge Solenoid Control harness is open or shorted
  • Evaporative Emission (EVAP) Purge Solenoid Control circuit poor electrical connection

Code Tech Notes

It's a very common problem with Nissan vehicles. If the harness is not damage it's very likely that the problem is the canister purge volume control solenoid valve.

⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC P0445 2010 Nissan Rogue?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0445 2010 Nissan Rogue Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0445 2010 Nissan Rogue code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

An excessively high voltage signal is sent to Engine Control Module (ECM) through the valve

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P0445 2010 Nissan Rogue Code Mean?

The Evaporative Emission System (EVAP) Canister Purge Volume Control Solenoid Valve controls flow rate of fuel vapor from the EVAP canister. The opening of the vapor by-pass passage in the EVAP canister purge volume control solenoid valve changes to control the flow rate. The EVAP canister purge volume control solenoid valve repeats ON/OFF operation according to the signal sent from the Engine Control Module (ECM). The opening of the valve varies for optimum engine control. The optimum value stored in the ECM is determined by considering various engine conditions. When the engine is operating, the flow rate of fuel vapor from the EVAP canister is regulated as the air flow changes.
The EVAP canister purge volume control solenoid valve uses a ON/OFF duty to control the flow rate of fuel vapor from the EVAP canister. The EVAP canister purge volume control solenoid valve is moved by ON/OFF pulses from the ECM. The longer the ON pulse, the greater the amount of fuel vapor that will flow through the valve.
P0445 2010 Nissan Rogue Code - EVAP Canister Purge Volume Control Solenoid Valve Circuit Shorted

Need more Information on the Code?

Need more information on how to fix the P0445 2010 Nissan Rogue code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0445 2010 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area