Engine-Codes - Nissan - P0441 2010 Nissan Rogue

P0441 2010 Nissan Rogue Code - Evaporative Control System Incorrect Purge Flow

- Code Popularity: 2,475 Views
- Repair Importance Level: 1/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0441 2010 Nissan Rogue?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • EVAP canister purge volume control solenoid valve stuck closed
  • EVAP control system pressure sensor and the circuit
  • Loose, disconnected or improper connection of rubber tube
  • Blocked rubber tube
  • Cracked EVAP canister
  • EVAP canister purge volume control solenoid valve circuit
  • Accelerator pedal position sensor
  • Blocked purge port
  • EVAP canister vent control valve

Code Tech Notes

The P0441 code means that the control module has detected a leak in the Evaporative Emission (EVAP). Loose fuel tank filler cap is the most common cause that triggers the P0441 code.

⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC P0441 2010 Nissan Rogue?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0441 2010 Nissan Rogue Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0441 2010 Nissan Rogue code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

EVAP control system does not operate properly, EVAP control system has a leak between intake manifold and EVAP control system pressure sensor.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • A noticeable fuel odor may result from fuel vapor release

What Does the P0441 2010 Nissan Rogue Code Mean?

The Engine Control Module (ECM) tests the Evaporative Emission (EVAP) system for the following conditions:
- Large and small leaks
- Excess vacuum
- Purge flow during non-commanded conditions
- Fuel Level and Fuel Pressure sensor faults
- EVAP Purge and Vent Valve faults
The ECM monitors the Fuel Tank Pressure sensor in order to determine the level of vacuum/pressure in the EVAP system. The ECM commands both the EVAP Purge Solenoid and the EVAP Vent Valve ON when the conditions are met in order to apply an engine vacuum to the EVAP system. The ECM commands the EVAP Purge Solenoid OFF once the system has reached a predetermined level of vacuum. This test verifies if a vacuum can be achieved in the EVAP system. Failure to develop a vacuum may be caused by a large leak or a restriction.
P0441 2010 Nissan Rogue Code - Evaporative Control System Incorrect Purge Flow

Need more Information on the Code?

Need more information on how to fix the P0441 2010 Nissan Rogue code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0441 2010 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area