P0430 HUMMER Code - Catalyst System Low Efficiency Bank 2
|P0430 HUMMER code possible causes
- Faulty Three-way Catalyst Converter Bank 2
- Exhaust Tube
- Intake Air Leaks
- Faulty Oxygen (O2) Sensor
- Faulty Fuel injector(s)
- Leaking Fuel Injector (s)
- Faulty Spark plugs
- Improper Ignition Timing
- Faulty Engine Control Module (ECM)
- Dirty Air Filter
|How is the P0430 HUMMER code repair?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|P0430 HUMMER code tech notes
As the code description implies the P0430 code means that the vehicle's control module has detected that the three-way catalytic converter is not working properly (is not as efficient as the factory is expecting). Replacing the oxygen (O2) sensors may sometimes fix the code, but in most cases, the catalytic convert needs to be replaced to fix the problem. If the P0430 code is combined with other codes, try fixing the other codes first.
|What is the cost to diagnose the P0430 HUMMER code
The cost to diagnose the P0430 HUMMER code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|When is the P0430 HUMMER code detected?
If a condition exists which causes the Powertrain Control Module (PCM) to detect excessive Bank 2 HO2S #2 activity outside of an acceptable range for an extended period of time, the PCM will set the P0420 code. This indicates that the three-way catalytic converters oxygen storage capacity is below a threshold considered acceptable.
|What are P0430 HUMMER code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
|What is P0430 HUMMER code meaning?
In order to maintain a reasonably low emissions of Hydrocarbons (HC), Carbon Monoxide (CO), and Oxides of Nitrogen (NOx), the engine controls system uses a three-way catalytic converter. The catalyst within the converter promotes a chemical reaction which oxidizes the HC and CO present in the exhaust gas. This reaction converts them into harmless water vapor and Carbon Dioxide. The catalyst also reduces NOx, converting it to Nitrogen. The Powertrain Control Module (PCM
) monitors this process using Bank
2 HO2S #2. Bank
2 HO2S #2, located in the exhaust stream past the three-way catalytic converter, produces an output signal which indicates the oxygen storage capacity of the catalyst. This determines the catalysts ability to convert exhaust emissions effectively. If the catalyst is functioning correctly, the Bank
2 HO2S #2 signal will be far less active than that produced by Bank
2 HO2S #1.