Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
On some Chevrolet models, the camshaft position sensor is part Ignition Control Module (ICM) (aka igniter)
The cost to diagnose the P0340 CHEVROLET code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The Camshaft Position Sensor detects magnetic flux changes between the four narrow and wide tooth slots on the reluctor wheel. The Camshaft Position Sensor provides a digital ON/OFF DC voltage of varying frequency for each camshaft revolution. The Engine Control Module (ECM) will recognize the narrow and wide tooth patterns to identify the camshaft position, or which cylinder is in compression, and which is in the exhaust. The information is then used to determine the correct time and sequence for fuel injection and ignition spark events.
The ECM also has a dedicated replicated Camshaft Position Sensor signal output circuit that may be used as an input signal to other modules for monitoring engine RPM.
The Diagnostic Trouble Code (DTC) will be set when the ECM does not receive a signal from the Camshaft Position Sensor during 200 engine revolutions.
Need more information on how to fix the P0340 CHEVROLET code?
Get Access to Factory Service Manuals
Get the p0340 chevrolet code diagnosed by a professional: Find a repair shop in your area