Engine-Codes - Nissan - P0340 2011 NISSAN ROGUE

P0340 2011 NISSAN ROGUE Code - Camshaft Position Sensor Circuit Bank 1

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3
Table of contents

|P0340 2011 NISSAN ROGUE code possible causes

  • Faulty Camshaft Position Sensor
  • Camshaft Position Sensor harness is open or shorted
  • Camshaft Position Sensor circuit poor electrical connection
  • Faulty starter motor
  • Starting system circuit
  • Dead (Weak) battery

|How is the P0340 2011 NISSAN ROGUE code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|P0340 2011 NISSAN ROGUE code tech notes

Sometimes and in some models, low battery voltage or a weak starter can trigger a Camshaft Position Sensor code. Before replacing any parts, recharge or replace the battery.

|What is the cost to diagnose the P0340 2011 NISSAN ROGUE code

Labor: 1.0

The cost to diagnose the P0340 2011 NISSAN ROGUE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|When is the P0340 2011 NISSAN ROGUE code detected?

The camshaft position sensor signal is not detected by the Engine Control Module(ECM) during the first few seconds of engine cranking

|What are P0340 2011 NISSAN ROGUE code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of Power
  • Engine Stall

|What is P0340 2011 NISSAN ROGUE code meaning?

The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module(ECM) to control ignition and fuel injection. The camshaft position sensor senses the retraction of camshaft (intake) to identify a particular cylinder. The camshaft position sensor senses the piston position. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor provides various controls of engine parts instead, utilizing timing of cylinder identification signals.

|Need more information with the P0340 2011 NISSAN ROGUE code?

Need more information on how to fix the P0340 2011 NISSAN ROGUE code?
Get Access to Factory Service Manuals

|Need help with a P0340 2011 NISSAN ROGUE code?

Get the P0340 2011 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area