P0340 2009 FORD FUSION - Camshaft Position Sensor Circuit Bank 1 Sensor 1
P0340 2009 FORD FUSION Possible Causes
- Faulty Camshaft Position (CMP) Sensor
- Camshaft Position Sensor harness is open or shorted
- Camshaft Position Sensor circuit poor electrical connection
- Faulty Powertrain Control Module (PCM)
How is the P0340 2009 FORD FUSION code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P0340 2009 FORD FUSION code
Labor: 1.0The cost to diagnose the P0340 2009 FORD FUSION code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of Power
- Engine Stall
P0340 2009 FORD FUSION MeaningThe Camshaft Position (CMP) sensor detects the position of the camshaft. The CMP sensor identifies when piston number 1 is on its compression stroke. A signal is then sent to the Powertrain Control Module (PCM) and used for synchronizing the sequential firing of the fuel injectors. Coil on plug (COP) ignition applications use the CMP signal to select the correct ignition coil to fire. Inline engines with 2 camshafts and with Variable Camshaft Timing (VCT) are equipped with 2 CMP sensors. The second sensor identifies the position of the exhaust camshaft. The Diagnostic Trouble Code (DTC) will set when the Powertrain Control Module can no longer detect the signal from the Camshaft Position (CMP) sensor on bank 1.
More InformationNeed more information on how to fix the P0340 2009 FORD FUSION code?
Get Access to Factory Service Manuals