Engine-Codes - Toyota - P0335 2010 Toyota Camry

P0335 2010 Toyota Camry Code - Crankshaft Position Sensor 'A' Circuit

- Code Popularity: 8,792 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents

|What are the Possible Causes of the Code P0335 2010 Toyota Camry?

  • Faulty crankshaft position sensor
  • Crankshaft position sensor harness is open or shorted
  • Crankshaft position sensor circuit poor electrical connection
  • Signal plate may be damage
  • Starter motor may be faulty
  • Starting system circuit
  • Dead or weak battery

|How to Fix the P0335 2010 Toyota Camry Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Code P0335 2010 Toyota Camry Tech Notes

Sometimes and in some models, low battery voltage or a weak starter can trigger a Crankshaft Position Sensor code. Before replacing any parts, recharge or replaced battery.

|What is the Cost to Diagnose the Code P0335 2010 Toyota Camry?

Labor: 1.0

The cost to diagnose the P0335 2010 Toyota Camry code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your car have Safety Recalls? → Check here

|When is the P0335 2010 Toyota Camry Code Detected?

The crankshaft position sensor (POS) signal is not detected by the Electronic Control Module (ECM) during the first few seconds of engine cranking

|What are Code P0335 2010 Toyota Camry Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Possible lack/loss of Power
  • Engine may stall while driving

|What Does the P0335 2010 Toyota Camry Code Mean?

The Crankshaft Position (CKP) sensor system consists of a CKP sensor plate and a pickup coil. The sensor plate has teeth and is installed on the crankshaft. The pickup coil is made of wound copper wire, an iron core and magnet. The sensor plate rotates and, as each tooth passes through the pickup coil, a pulse signal is created. The pickup coil generates signals per engine revolution. Based on these signals, the ECM calculates the crankshaft position and engine RPM. Using these calculations, the fuel injection time and ignition timing are controlled.

Crankshaft Position Sensor 'A' Circuit

|Need more Information on the P0335 2010 Toyota Camry Code?

Need more information on how to fix the P0335 2010 Toyota Camry code? Get Access to Factory Service Manuals

|Need Help with the P0335 2010 Toyota Camry Code?

Get the P0335 2010 Toyota Camry code diagnosed by a professional: Find a repair shop in your area