P0327 2010 NISSAN ROGUE - Knock Sensor Circuit Low Input Bank 1
P0327 2010 NISSAN ROGUE Possible Causes
- Faulty knock sensor
- Knock sensor circuit poor electrical connection
- Knock sensor harness is open or shorted
- Faulty Engine Control Module (ECM)
How is the P0327 2010 NISSAN ROGUE code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P0327 2010 NISSAN ROGUE code
Labor: 1.0The cost to diagnose the P0327 2010 NISSAN ROGUE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?An excessively low voltage from the sensor is sent to Engine Control Module (ECM)
- Engine Light ON (or Service Engine Soon Warning Light)
- Possible Lack/Loss of Power
P0327 2010 NISSAN ROGUE MeaningThe knock sensor is attached to the cylinder block. It senses engine knocking using a piezoelectric element. A knocking vibration from the cylinder block is sensed as vibrational pressure. This pressure is converted into a voltage signal and sent to the Engine Control Module (ECM).
More InformationNeed more information on how to fix the P0327 2010 NISSAN ROGUE code?
Get Access to Factory Service Manuals