P0320 Dodge Code - No Crank Reference Signal At PCM
Quick Answer
The P0320 diagnostic trouble code (DTC) for Dodge vehicles indicates that there is no crank reference signal being received by the Powertrain Control Module (PCM). Common causes include Faulty crankshaft position sensor, Wiring or connector issues in the crankshaft position sensor circuit, PCM failure. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P0320 Dodge indicates No Crank Reference Signal At PCM.
- Common causes
- Common causes include Faulty crankshaft position sensor, Wiring or connector issues in the crankshaft position sensor circuit, PCM failure.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
Code P0320 Dodge Description
The P0320 diagnostic trouble code (DTC) for Dodge vehicles indicates that there is no crank reference signal being received by the Powertrain Control Module (PCM). This signal is crucial for the PCM to properly control ignition timing and fuel delivery, as it provides information about the position of the crankshaft in relation to the camshaft. Without this signal, the PCM may not be able to start the engine or run it smoothly.
Common Causes of P0320 Dodge
- Faulty crankshaft position sensor.
- Wiring or connector issues in the crankshaft position sensor circuit.
- PCM failure.
- Crankshaft position sensor out of alignment.
- Engine timing belt or chain issues.
Symptoms of P0320 Dodge
- Engine cranks but does not start.
- Engine stalling or running rough.
- Loss of power while driving.
- Check Engine Light illuminated.
- Difficulty starting the vehicle.
How to Fix P0320 Dodge
- Diagnose the issue by using a scan tool to check for the P0320 code and perform a visual inspection of the crankshaft position sensor and related wiring.
- Test the crankshaft position sensor using a multimeter to ensure it is functioning properly.
- Replace the crankshaft position sensor if it is found to be faulty.
- Check and repair any damaged or corroded wiring or connectors in the sensor circuit.
- Clear the DTC and test drive the vehicle to ensure the issue has been resolved.
Cost to Fix P0320 Dodge
The cost of repairing a P0320 code on a Dodge vehicle can vary depending on the specific cause of the issue. In general, replacing a faulty crankshaft position sensor can cost between $50 and $150 for the part alone. Labor costs can range from $100 to $200, depending on the shop's hourly rates and the complexity of the repair. Overall, the total cost can be anywhere from $150 to $350. It's important to note that these are rough estimates, and actual costs may differ based on various factors.
When is the Code Detected?
Need more information about the P0320 Dodge code?
Need more information on how to fix the P0320 Dodge code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0320 Dodge code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0320 Dodge Code
No Frequently Asked Questions about P0320 Dodge Code found.
Discuss the causes and fixes for P0320 Dodge OBDII Code
Code P0320 Dodge comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.