Engine-Codes - Ford - P0298 1999 Ford F150

P0298 1999 Ford F150 Code - Engine Oil Over Temperature Condition

- Code Popularity: 1,805 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0298 1999 Ford F150?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Engine overheating condition
  • Very high engine RPM for an extended period of time
  • Low or dirty motor oil condition
  • Faulty Oil Pressure Switch
  • Faulty Engine Oil Temperature (EOT) sensor

Code Tech Notes

Indicates the Engine Oil Temperature Protection strategy in the PCM has been activated. This will temporarily prohibit high engine speed operation by disabling injectors, therefore reducing the risk of engine damage from high engine oil temperature. Note: On engines which are equipped with an oil temperature sensor, the PCM reads oil temperature to determine if it is excessive. When an oil temperature sensor is not present, the PCM uses an oil algorithm to infer actual temperature. Engine shutdown strategy function is the same on vehicles with and without oil temperature sensors.

⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P0298 1999 Ford F150?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0298 1999 Ford F150 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0298 1999 Ford F150 code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

P0298 is set when the vehicle has been running below 1,000 rpm and less than 20 mg/stroke MFDES with EOT sensor signal reading above 110 C (230 F). The time to set the fault is dependent on EOT and Intake Air Temperature (IAT) temperatures, and can vary between approx. 15 to 45 minutes

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P0298 1999 Ford F150 Code Mean?

Indicates the Engine Oil Temperature Protection (EOT) strategy in the Engine Control Module (ECM) has been activated. This temporarily prohibits high engine speed operation by disabling injectors, reducing the risk of engine damage from high engine oil temperature.

P0298 1999 Ford F150 Code - Engine Oil Over Temperature Condition

Need more Information on the Code?

Need more information on how to fix the P0298 1999 Ford F150 code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0298 1999 Ford F150 code diagnosed by a professional: Find a repair shop in your area