Engine-Codes - Toyota - P0223 2010 Toyota Camry

P0223 2010 Toyota Camry Code - Throttle/Pedal Position Sensor/Switch 'B' Circuit High Input

- Code Popularity: 2,011 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0223 2010 Toyota Camry?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Throttle position sensor
  • Throttle position sensor harness is open or shorted
  • Throttle position sensor poor electrical connection
  • ECM
⚠ Does your Toyota have Safety Recalls? → Check here

How to Fix the DTC P0223 2010 Toyota Camry?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0223 2010 Toyota Camry Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0223 2010 Toyota Camry code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

An excessively high voltage from the Throttle Position Sensor (TPS) is sent to Engine Control Module (ECM).

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • No throttle response

What Does the P0223 2010 Toyota Camry Code Mean?

The TP sensor is mounted on the throttle body, and detects the opening angle of the throttle valve. This sensor is a non-contact type. It uses Hall-effect elements in order to yield accurate signals even in extreme driving conditions, such as at high speeds as well as very low speeds. The TP sensor has two sensor circuits which each transmits a signal, VTA1 and VTA2. VTA1 is used to detect the throttle valve angle and VTA2 is used to detect malfunctions in VTA1. The sensor signal voltages vary between 0 V and 5 V in proportion to the throttle valve opening angle, and are transmitted to the VTA terminals of the ECM.
As the valve closes, the sensor output voltage decreases and as the valve opens, the sensor output voltage increases. The ECM calculates the throttle valve opening angle according to these signals and controls the throttle actuator in response to driver inputs. These signals are also used in calculations such as air-fuel ratio correction, power increase correction and fuel-cut control.

P0223 2010 Toyota Camry Code - Throttle/Pedal Position Sensor/Switch 'B' Circuit High Input

Need more Information on the Code?

Need more information on how to fix the P0223 2010 Toyota Camry code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0223 2010 Toyota Camry code diagnosed by a professional: Find a repair shop in your area