Engine-Codes
 
OBDII Code List
 
P0190 2000 FORD F150

P0190 2000 FORD F150 - Fuel Rail Pressure Sensor Circuit Malfunction

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What does this mean?

P0190 2000 FORD F150 Possible Causes

  • Low or no fuel
  • Faulty Rail Pressure (FRP) Sensor
  • FRP harness is open or shorted
  • FRP circuit poor electrical connection
  • Faulty Fuel Pump

P0190 2000 FORD F150 Tech Notes

The comprehensive component monitor (CCM) monitors the FRP sensor to the PCM for VREF voltage. The test fails when the VREF voltage from the PCM drops to a voltage less than a minimum calibrated value.
Verify VREF voltage between 4.0 and 6.0V.

Cost of diagnosing the P0190 2000 FORD F150 code

    Labor: 1.0

    The cost of diagnosing the P0190 2000 FORD F150 code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

P0190 2000 FORD F150 Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine will not start

P0190 2000 FORD F150 Meaning

The FRP sensor is a diaphragm strain gauge device. The FRP sensor measures the pressure difference between the fuel rail and atmospheric pressure. The FRP sensor nominal output varies between 0.5 and 4.5 volts, with 0.5 volts corresponding to 0 MPa (0 psi) gauge and 4.5 volts corresponding to 26 MPa (3771 psi) gauge. The sensor can read vacuums and may lower the output voltage to slightly below 0.5 volts. This condition is normal and is usually the case after several hours of cold soak before the vehicle dome light is turned on. The FP module is energized at the same time the dome light is commanded on. A disabled or malfunctioning dome light does not affect the FP module control.

The FRP sensor is located on the fuel rail, and provides a feedback signal to indicate the fuel rail pressure to the Powertrain Control Module (PCM). The PCM uses the FRP signal to command the correct injector timing and pulse width for correct fuel delivery at all speed and load conditions. The FRP sensor, along with the fuel volume regulator (part of the fuel injection pump), form a closed loop fuel pressure control system. An electrically faulted FRP sensor results in the deactivation of the fuel injection pump. Fuel pressure to injectors is then provided only by the FP module. When the fuel injection pump is de-energized and the injectors are active, the fuel rail pressure is approximately 70 kPa (10 psi) lower than FP module pressure due to the pressure drop across the fuel injection pump. Thus, if the FP module pressure is 448 kPa (65 psi), then the fuel rail pressure would be approximately 379 kPa (55 psi) if the injectors are active.

OBDII Code P0190 2000 FORD F150 - Fuel Rail Pressure Sensor Circuit Malfunction  - Engine-Codes.com

Related Information