P0180 2011 FORD FUSION - Engine Fuel Temperature Sensor 'A' Circuit
P0180 2011 FORD FUSION Possible Causes
- Open or short in the harness
- Low ambient temperature operation
- Incorrect harness connection
- Damaged fuel temperature sensor
How is the P0180 2011 FORD FUSION code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P0180 2011 FORD FUSION code
Labor: 1.0The cost to diagnose the P0180 2011 FORD FUSION code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
When is the code detected?An excessively high or low voltage is sent to Powertrain Control Module (PCM) by the Engine Fuel Temperature (EFT) Sensor.
- Engine Light ON (or Service Engine Soon Warning Light)
P0180 2011 FORD FUSION MeaningThe comprehensive component monitor (CCM) monitors the Engine Fuel Temperature (EFT) Sensor circuit to the Powertrain Control Module (PCM) for low and high voltage. If voltage were to fall below or exceed a calibrated limit and amount of time during testing, the test will fail. Open or short in harness. Low ambient temperature operation.
More InformationNeed more information on how to fix the P0180 2011 FORD FUSION code?
Get Access to Factory Service Manuals