Engine-Codes - Oldsmobile - P0174 OLDSMOBILE

P0174 OLDSMOBILE - Fuel Trim System Lean Bank 2

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What is this?
Table of contents

P0174 OLDSMOBILE Possible Causes

  • Intake air leaks
  • Faulty front heated oxygen sensor
  • Ignition misfiring
  • Faulty fuel injectors
  • Exhaust gas leaks
  • Incorrect fuel pressure
  • Lack of fuel
  • Faulty Mass Air Flow (MAF) sensor
  • Incorrect Positive Crankcase Ventilation (PCV) hose connection

How is the P0174 OLDSMOBILE code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Tech Notes

If the P0171 is combined with the P0174 code, it's very likely that the problem is caused by an intake leak. If there are no intake leaks, the next step is to replace the air filter and clean the air flow meter. If the problem persists the front oxygen (O2) sensor may need to be replaced.
The P0174 code could also be caused may be caused by one or more of the following: debris on the MAF sensor causing an incorrect reading, improper oil level, low or high fuel pressure, or Engine Control Temperature (ECT) Sensor reading inaccurate.

There is a Factory Service Bulletin for the following Oldsmobile models:
2000-2004 Oldsmobile Alero
2000-2005 Oldsmobile Silhouette
2002-2004 Oldsmobile Bravada
2000-2004 Oldsmobile Factory Service Bulletin OBDII Code P0174

What is the cost to diagnose the P0174 OLDSMOBILE code

Labor: 1.0

The cost to diagnose the P0174 OLDSMOBILE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

When is the code detected?

- Fuel injection system does not operate properly.
- The amount of mixture ratio compensation is too small. (The mixture ratio is too lean.)

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Excessive Fuel Consumption

P0174 OLDSMOBILE Meaning

The Engine Control Module (ECM) controls the air/fuel metering system in order to provide the best possible combination of driveability, fuel economy, and emission control. Fuel delivery is controlled differently during Open Loop and Closed Loop. During Open Loop, the ECM determines fuel delivery based on sensor signals without heated oxygen sensor (HO2S) input. During Closed Loop, the ECM adds HO2S inputs to calculate the short and long term fuel trim (FT) adjustments. If the HO2S indicates a lean condition, the fuel trim values will be above 0 percent. If the HO2S indicates a rich condition, the FT values will be below 0 percent. The short term FT values change rapidly in response to the HO2S voltage signals. The long term FT makes coarse adjustments in order to maintain an air/fuel ratio of 14.7:1.

More Information

Need more information on how to fix the P0174 OLDSMOBILE code?
Get Access to Factory Service Manuals

Need more help?

Get the P0174 Oldsmobile code diagnosed by a professional: Find a repair shop in your area