Engine-Codes
 
OBDII Code List
 
P014D 2013 NISSAN ROGUE

P014D 2013 NISSAN ROGUE - Air Fuel Ratio Sensor Slow Response - Lean To Rich Bank 1 sensor 1

Repair Importance Level: 2/3
Repair Difficulty Level: 2/3  What does this mean?

P014D 2013 NISSAN ROGUE Possible Causes

  • Faulty Air Fuel Ratio (A/F) Bank 1 Sensor 1
  • Air Fuel Ratio (A/F) Bank 1 Sensor 1 harness is open or shorted
  • Air Fuel Ratio (A/F) Bank 1 Sensor 1 circuit poor electrical connection

First diagnose P014D 2013 NISSAN ROGUE code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

P014D 2013 NISSAN ROGUE Tech Notes

Replacing the Air Fuel Ratio Bank 1 Sensor 1 usually takes care of the problem.

Cost of diagnosing the P014D 2013 NISSAN ROGUE code

    Labor: 1.0

    The cost of diagnosing the P014D 2013 NISSAN ROGUE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

When is the P014D 2013 NISSAN ROGUE code detected?

The response time of a A/F sensor 1 signal delays more than the specified time computed by Engine Control Module (ECM).

P014D 2013 NISSAN ROGUE Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • High Fuel Consumption
  • Excessive Smoke from Exhaust

P014D 2013 NISSAN ROGUE Meaning

The air fuel ratio (A/F) sensor 1 is a planar one-cell limit current sensor. The sensor element of the A/F sensor 1 is composed an electrode layer, which transports ions. It has a heater in the element. The sensor is capable of precise measurement λ = 1, but also in the lean and rich range. Together with its control electronics, the sensor outputs a clear, continuous signal throughout a wide λ range. The exhaust gas components diffuse through the diffusion layer at the sensor cell. An electrode layer is applied voltage, and this current relative oxygen density in lean. Also this current relative hydrocarbon density in rich.

Therefore, the A/F sensor 1 is able to indicate air fuel ratio by this electrode layer of current. In addition, a heater is integrated in the sensor to ensure the required operating temperature of approximately 760°C (1,400°F).

OBDII Code P014D 2013 NISSAN ROGUE - Air Fuel Ratio Sensor Slow Response - Lean To Rich Bank 1 sensor 1 - Engine-Codes.com

P014D 2013 NISSAN ROGUE More Information

Need more information on how to fix the P014D 2013 NISSAN ROGUE code?
Get Access to Factory Service Manuals

Related Information