P0133 2009 NISSAN ROGUE - Air Fuel Ratio Circuit Slow Response Bank 1 Sensor 1
P0133 2009 NISSAN ROGUE Possible Causes
- Faulty Air fuel ratio (A/F) sensor 1 bank 1
- Air fuel ratio (A/F) sensor 1 bank 1 harness is open or shorted
- Air fuel ratio (A/F) sensor 1 bank 1 circuit poor electrical connection
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks
How is the P0133 2009 NISSAN ROGUE code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P0133 2009 NISSAN ROGUE code
Labor: 1.0The cost to diagnose the P0133 2009 NISSAN ROGUE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?The Air Fuel Ratio (A/F) signal computed by Engine Control Module (ECM) from the A/F sensor 1 signal takes more than the specified time
- Engine Light ON (or Service Engine Soon Warning Light)
- High Fuel Consumption
- Excessive Smoke from Exhaust
P0133 2009 NISSAN ROGUE MeaningThe Air Fuel Ratio (A/F) sensor is a planar dual-cell limit current sensor. The sensor element of the A/F sensor is the combination of a Nernst concentration cell (sensor cell) with an oxygen-pump cell, which transports ions. It has a heater in the element.
The sensor is capable of precise measurement λ= 1, but also in the lean and rich range. Together with its control electronics, the sensor outputs a clear, continuous signal throughout a wide range (0.7 < λ < air).
The exhaust gas components diffuse through the diffusion gap at the electrode of the oxygen pump and Nernst concentration cell, where they are brought to thermodynamic balance. An electronic circuit controls the pump current through the oxygen pump cell so that the composition of the exhaust gas in the diffusion gap remains constant at λ = 1. Therefore, the A/F sensor is able to indicate air/fuel ratio by this pumping of current. In addition, a heater is integrated in the sensor to ensure the required operating temperature of 700 - 800°C (1,292 - 1,472°F).
More InformationNeed more information on how to fix the P0133 2009 NISSAN ROGUE code?
Get Access to Factory Service Manuals