P0123 2013 NISSAN ROGUE - Throttle Position Sensor/Switch '1' Circuit High Input
P0123 2013 NISSAN ROGUE Possible Causes
- Faulty throttle position sensor
- Throttle position sensor harness is open or shorted
- Throttle position sensor circuit poor electrical connection
How is the P0123 2013 NISSAN ROGUE code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P0123 2013 NISSAN ROGUE code
Labor: 1.0The cost to diagnose the P0123 2013 NISSAN ROGUE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
When is the code detected?An excessively high voltage from the Throttle Position Sensor (TPS) '1' is sent to Engine Control Module (ECM).
- Engine Light ON (or Service Engine Soon Warning Light)
P0123 2013 NISSAN ROGUE MeaningThe Throttle Position Sensor (TPS) responds to the accelerator pedal movement. This sensor is a kind of potentiometer which transforms the throttle position into output voltage, and emits the voltage signal to the Engine Control Module (ECM). In addition, the sensor detects the opening and closing speed of the throttle valve and feeds the voltage signal to the ECM.
Idle position of the throttle valve is determined by the ECM receiving the signal from the throttle position sensor. This sensor controls engine operation such as fuel cut. On the other hand, the Wide open and closed throttle position switch, which is built into the throttle position sensor unit, is not used for engine control.
More InformationNeed more information on how to fix the P0123 2013 NISSAN ROGUE code?
Get Access to Factory Service Manuals