P0122 2008 NISSAN SENTRA - Throttle Position Sensor/Switch 'A' Circuit Low Input
P0122 2008 NISSAN SENTRA Possible Causes
- Faulty throttle position sensor 2
- Throttle position sensor 2 harness is open or shorted
- Throttle position sensor 2 circuit poor electrical connection
How is the P0122 2008 NISSAN SENTRA code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P0122 2008 NISSAN SENTRA code
Labor: 1.0The cost to diagnose the P0122 2008 NISSAN SENTRA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?An excessively low voltage from the Throttle Position Sensor (TPS) is sent to Engine Control Module (ECM).
- Engine Light ON (or Service Engine Soon Warning Light)
P0122 2008 NISSAN SENTRA MeaningThe Throttle Pedal Position (TPP) responds to the accelerator pedal movement. This sensor is a kind of potentiometer which transforms the throttle position into output voltage, and emits the voltage signal to the Engine Control Module (ECM). In addition, the sensor detects the opening and closing speed of the throttle valve and feeds the voltage signal to the ECM.
Idle position of the throttle valve is determined by the ECM receiving the signal from the throttle position sensor. This sensor controls engine operation such as fuel cut. On the other hand, the Wide open and closed throttle position switch, which is built into the throttle position sensor unit, is not used for engine control.
More InformationNeed more information on how to fix the P0122 2008 NISSAN SENTRA code?
Get Access to Factory Service Manuals