P0119 2010 Ford Fusion Code - Engine Coolant Temperature Sensor 1 Circuit Intermittent
Quick Answer
The P0119 diagnostic trouble code (DTC) for a 2010 Ford Fusion refers to the Engine Coolant Temperature Sensor 1 Circuit Intermittent. Common causes include Faulty Engine Coolant Temperature Sensor: The most common cause of the P0119 code is a defective engine coolant temperature sensor, Wiring Issues: Damaged or corroded wiring/connectors between the engine coolant temperature sensor and the ECM/PCM can lead to intermittent signals, Poor Electrical Ground: A weak or poor electrical ground connection can also cause intermittent signals from the engine coolant temperature sensor. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P0119 2010 Ford Fusion indicates Engine Coolant Temperature Sensor 1 Circuit Intermittent.
- Common causes
- Common causes include Faulty Engine Coolant Temperature Sensor: The most common cause of the P0119 code is a defective engine coolant temperature sensor, Wiring Issues: Damaged or corroded wiring/connectors between the engine coolant temperature sensor and the ECM/PCM can lead to intermittent signals, Poor Electrical Ground: A weak or poor electrical ground connection can also cause intermittent signals from the engine coolant temperature sensor.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
Code P0119 2010 Ford Fusion Description
The P0119 diagnostic trouble code (DTC) for a 2010 Ford Fusion refers to the Engine Coolant Temperature Sensor 1 Circuit Intermittent. This means that the engine coolant temperature sensor is sending intermittent signals to the engine control module (ECM), also known as the powertrain control module (PCM). The engine coolant temperature sensor is a crucial component of the vehicle's engine management system, as it helps the ECM/PCM adjust fuel delivery and ignition timing based on the engine's operating temperature.
Common Causes of P0119 2010 Ford Fusion
- Faulty Engine Coolant Temperature Sensor: The most common cause of the P0119 code is a defective engine coolant temperature sensor.
- Wiring Issues: Damaged or corroded wiring/connectors between the engine coolant temperature sensor and the ECM/PCM can lead to intermittent signals.
- Poor Electrical Ground: A weak or poor electrical ground connection can also cause intermittent signals from the engine coolant temperature sensor.
- Coolant Level: Low coolant level or air bubbles in the cooling system can affect the accuracy of the sensor readings.
- ECM/PCM Malfunction: In rare cases, a malfunctioning ECM/PCM could be the underlying cause of the intermittent signals from the engine coolant temperature sensor.
Symptoms of P0119 2010 Ford Fusion
- Check Engine Light: The most common symptom associated with the P0119 code is the illumination of the check engine light on the vehicle's dashboard.
- Engine Performance Issues: The vehicle may experience rough idling, stalling, or hesitation during acceleration due to incorrect fuel delivery and ignition timing.
- Poor Fuel Efficiency: A faulty engine coolant temperature sensor can lead to decreased fuel efficiency, as the ECM/PCM may not be able to adjust fuel delivery accurately.
- Overheating or Cooling Issues: The vehicle may experience issues with overheating or not reaching the optimal operating temperature due to inaccurate temperature readings from the sensor.
How to Fix P0119 2010 Ford Fusion
- Diagnose the Issue: Use an OBD-II scanner to retrieve the fault code and perform a thorough inspection of the engine coolant temperature sensor, wiring, and connectors.
- Replace the Engine Coolant Temperature Sensor: If the sensor is found to be faulty, replace it with a new one following the manufacturer's guidelines.
- Check Wiring and Connectors: Inspect the wiring and connectors for any damage or corrosion and repair or replace them as needed.
- Verify Coolant Level: Ensure the coolant level is at the proper level and bleed the cooling system to remove any air bubbles.
- Clear Fault Code: After completing the repairs, clear the fault code using the OBD-II scanner and perform a test drive to verify that the issue has been resolved.
Cost to Fix P0119 2010 Ford Fusion
The cost of repairing the P0119 code for a 2010 Ford Fusion can vary depending on the cost of parts and labor. On average, the cost of replacing the engine coolant temperature sensor ranges from $50 to $150, while the labor cost can range from $80 to $150 per hour. Overall, the total repair cost for this issue may range from $150 to $300, including parts and labor. It's important to note that the specific diagnosis time and labor rates at auto repair shops can vary, so it's advisable to check local rates for a more precise estimate.
Tech Notes for P0119 2010 Ford Fusion
When is the Code Detected?
Need more information about the P0119 2010 Ford Fusion code?
Need more information on how to fix the P0119 2010 Ford Fusion code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0119 2010 Ford Fusion code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0119 2010 Ford Fusion Code
1. What does the OBDII code P0119 mean on a 2010 Ford Fusion?
P0119 indicates an intermittent issue in the Engine Coolant Temperature (ECT) Sensor 1 circuit, meaning the sensor is not consistently sending proper signals to the engine control module (ECM).
2. What are common symptoms of the P0119 code in a Ford Fusion?
Symptoms may include engine overheating, poor fuel economy, hard starting, rough idling, or an illuminated check engine light.
3. What causes the P0119 code to appear?
Common causes include a faulty ECT sensor, damaged wiring or connectors, a stuck thermostat, or low coolant levels.
4. Can I drive my 2010 Ford Fusion with the P0119 code?
While it may be drivable, ignoring this code can lead to engine overheating or performance issues, so it’s best to address it promptly.
5. How do I troubleshoot the P0119 code on my Ford Fusion?
Start by checking the coolant level, inspecting the ECT sensor and its wiring for damage, and testing the thermostat for proper operation.
6. How do I fix the P0119 code on a 2010 Ford Fusion?
Repairs may involve replacing the ECT sensor, repairing damaged wiring, cleaning corroded connectors, or replacing a faulty thermostat.
7. Where is the Engine Coolant Temperature Sensor located in a 2010 Ford Fusion?
The ECT sensor is typically located near the engine’s thermostat housing, connected to the cooling system.
8. What tools do I need to diagnose and repair the P0119 code?
You’ll need an OBDII scanner, a multimeter for testing electrical connections, and basic hand tools for sensor or thermostat replacement.
9. How much does it cost to repair the P0119 code on a Ford Fusion?
The cost varies but typically ranges from $100 to $300, depending on whether the issue is with the sensor, wiring, or thermostat.
10. Will a bad thermostat cause the P0119 code?
Yes, a stuck thermostat can cause erratic coolant temperatures, leading to the P0119 code being triggered.
Discuss the causes and fixes for P0119 2010 Ford Fusion OBDII Code
Code P0119 2010 Ford Fusion comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.