P0112 Jeep Code - Intake Air Temperature Sensor 1 Circuit Low
Quick Answer
The P0112 code for Jeep vehicles indicates an issue with the Intake Air Temperature (IAT) Sensor 1 Circuit being too low. Common causes include Faulty Intake Air Temperature (IAT) sensor, Damaged wiring or connectors in the sensor circuit, Malfunctioning Engine Control Module (ECM). Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P0112 Jeep indicates Intake Air Temperature Sensor 1 Circuit Low.
- Common causes
- Common causes include Faulty Intake Air Temperature (IAT) sensor, Damaged wiring or connectors in the sensor circuit, Malfunctioning Engine Control Module (ECM).
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
Code P0112 Jeep Description
The P0112 code for Jeep vehicles indicates an issue with the Intake Air Temperature (IAT) Sensor 1 Circuit being too low. The IAT sensor is responsible for measuring the temperature of the air entering the engine. This information is crucial for the engine control module (ECM) to adjust the air-fuel mixture for optimal combustion. When the IAT sensor circuit is reading lower than expected, it can lead to incorrect fueling and ignition timing, ultimately affecting the vehicle's performance.
Common Causes of P0112 Jeep
- Faulty Intake Air Temperature (IAT) sensor
- Damaged wiring or connectors in the sensor circuit
- Malfunctioning Engine Control Module (ECM)
- Electrical interference affecting sensor readings
- Extreme temperature conditions affecting sensor accuracy
Symptoms of P0112 Jeep
- Decreased fuel efficiency
- Rough idling or stalling
- Hesitation on acceleration
- Engine misfires
- Increased emissions output
How to Fix P0112 Jeep
- Begin by locating the IAT sensor in the intake air duct or manifold.
- Inspect the sensor wiring and connectors for any damage or corrosion.
- Test the sensor using a multimeter to check for proper resistance.
- If the sensor is faulty, replace it with a new one.
- Clear the error code from the ECM memory and test drive the vehicle to ensure the issue is resolved.
Cost to Fix P0112 Jeep
The typical cost to repair the Intake Air Temperature Sensor 1 Circuit Low issue in a Jeep can range from $100 to $300, including parts and labor. However, prices may vary depending on the specific model of Jeep, the location of the repair shop, and the extent of the damage. It's recommended to consult with a professional mechanic to get an accurate estimate for your particular situation.
When is the Code Detected?
Need more information about the P0112 Jeep code?
Need more information on how to fix the P0112 Jeep code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0112 Jeep code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0112 Jeep Code
No Frequently Asked Questions about P0112 Jeep Code found.
Discuss the causes and fixes for P0112 Jeep OBDII Code
Code P0112 Jeep comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.