Engine-Codes - Mini - P0107 MINI

P0107 MINI Code - Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Low

- Code Popularity: 1,582 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents

|What are the Possible Causes of the Code P0107 MINI?

  • Faulty Manifold Absolute Pressure (MAP) Sensor
  • Manifold Absolute Pressure Sensor harness is open or shorted
  • Manifold Absolute Pressure Sensor circuit poor electrical connection
  • Faulty Engine Control Module (ECM)

|How to Fix the P0107 MINI Code?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|What is the Cost to Diagnose the Code P0107 MINI?

Labor: 1.0

The cost to diagnose the P0107 MINI code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Does your car have Safety Recalls? → Check here

|What are Code P0107 MINI Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What Does the P0107 MINI Code Mean?

The Manifold Absolute Pressure (MAP) sensor measures the pressure inside the intake manifold. Pressure in the intake manifold is affected by engine speed, throttle opening, air temperature, Barometric Pressure (BARO) and if equipped, turbocharger output. A diaphragm within the MAP sensor is displaced by the pressure changes that occur from the varying load and operating conditions of the engine. The sensor translates this action into electrical resistance.
The MAP sensor wiring includes 3 circuits. The Engine Control Module (ECM) supplies a regulated 5 volts to the sensor on a 5 V reference circuit. The ECM supplies ground on a low reference circuit. The MAP sensor provides a signal voltage to the ECM, relative to the pressure changes, on the MAP sensor signal circuit. The ECM converts the signal voltage input to a pressure value.
Under normal operation the greatest pressure that can exist in the intake manifold is at ignition ON, engine OFF, which is equal to the BARO. The lowest manifold pressure occurs when the vehicle is idling or decelerating. The ECM monitors the MAP sensor signal for pressure outside of the normal range.
The Diagnostic Trouble Code (DTC) will be set when the ECM detects that the MAP Sensor voltage is less than 0.15 V for greater than 13 ms.
Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Low

|Need more Information on the P0107 MINI Code?

Need more information on how to fix the P0107 MINI code? Get Access to Factory Service Manuals

|Need Help with the P0107 MINI Code?

Get the P0107 MINI code diagnosed by a professional: Find a repair shop in your area