Engine-Codes - Nissan - P0103 2012 Nissan Sentra

P0103 2012 Nissan Sentra Code - Mass Air Flow Sensor Circuit High Input

- Code Popularity: 4,461 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0103 2012 Nissan Sentra?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Dirty Air Filter
  • Dirty Mass Air Flow (MAF) Sensor
  • Intake air leaks
  • Faulty Mass Air Flow Sensor
  • Mass Air Flow Sensor harness is open or shorted
  • Mass Air Flow Sensor circuit poor electrical connection

Code Tech Notes

Before replacing the Mass Air Flow (MAF) Sensor, try replacing the air filter and cleaning the Mass Air Flow Sensor with low compress air or Mass Air Flow Sensor Cleaner. Reset code and drive vehicle. If the code comes back, you must replace the Mass Air Flow Sensor to fix the problem.

⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC P0103 2012 Nissan Sentra?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0103 2012 Nissan Sentra Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0103 2012 Nissan Sentra code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine stall
  • Engine running rough
  • Excessive fuel consumption
  • Excessive smoke

What Does the P0103 2012 Nissan Sentra Code Mean?

The Mass Air Flow (MAF) sensor is placed in the stream of the intake air. It measures the intake flow rate by measuring a part of the entire intake flow. It consists of a hot film that is supplied with electric current from the Engine Control Module (ECM). The ECM controls the temperature of the hot film by a certain amount. The heat generated by the hot film is reduced as the intake air flows around it. The more air, the greater the heat loss. Therefore, the ECM must supply more electric current to maintain the temperature of the hot film as air flow increases. The ECM detects the air flow by means of this current change. The Diagnostic Trouble Code (DTC) will be set when the ECM detects that the MAF Sensor Signal is more than the factory specifications.
P0103 2012 Nissan Sentra Code - Mass Air Flow Sensor Circuit High Input

Need more Information on the Code?

Need more information on how to fix the P0103 2012 Nissan Sentra code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0103 2012 Nissan Sentra code diagnosed by a professional: Find a repair shop in your area