P0100 2006 TOYOTA CAMRY - Mass or Volume Air Flow Circuit
P0100 2006 TOYOTA CAMRY Possible Causes
- Faulty mass air flow sensor
- Intake air leaks
- Dirty mass air flow sensor
- Dirty mass air filter
- Mass air flow sensor harness is open or shorted
- Mass air flow sensor circuit poor electrical connection
How do I fix code P0100 2006 TOYOTA CAMRY
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
P0100 2006 TOYOTA CAMRY Tech NotesBefore replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor.
Cost of diagnosing the P0100 2006 TOYOTA CAMRY code
Labor: 1.0The cost of diagnosing the P0100 2006 TOYOTA CAMRY code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the P0100 2006 TOYOTA CAMRY code detected?- A high voltage from the sensor is sent to Engine Control Module (ECM) under light load driving condition.
- A low voltage from the sensor is sent to ECM
P0100 2006 TOYOTA CAMRY Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Engine stall
- Engine running rough
- Excessive fuel consumption
- Excessive smoke
P0100 2006 TOYOTA CAMRY MeaningThe Mass Air Flow (MAF) sensor is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. It consists of a hot film that is supplied with electric current from the Engine Control Module (ECM).
The temperature of the hot film is controlled by the ECM a certain amount. The heat generated by the hot film is reduced as the intake air flows around it. The more air, the greater the heat loss. Therefore, the ECM must supply more electric current to maintain the temperature of the hot film as air flow increases. The ECM detects the air flow by means of this current change.
P0100 2006 TOYOTA CAMRY More InformationNeed more information on how to fix the P0100 2006 TOYOTA CAMRY code?
Get Access to Factory Service Manuals