Engine-Codes - Nissan - P0037 2012 NISSAN ALTIMA SEDAN

P0037 2012 NISSAN ALTIMA SEDAN Code - HO2S12 Heater Control Circuit Low

Repair Importance Level: 2/3
Repair Difficulty Level: 2/3  What is this?
Table of contents

|P0037 2012 NISSAN ALTIMA SEDAN code possible causes

  • Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 fuse
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 harness is open or shorted
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit poor electrical connection
  • Faulty Engine Control Module (ECM)

|How is the P0037 2012 NISSAN ALTIMA SEDAN code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|P0037 2012 NISSAN ALTIMA SEDAN code tech notes

The code means that there is a problem with the heater element circuit of the heated oxygen sensor. Water getting inside the heated oxygen sensor connector can caused the heated oxygen sensor fuse to blow, which is a very common problem for this type codes. Before replacing the sensor, check for the condition of the heated oxygen sensor fuse and connectors.

|What is the cost to diagnose the P0037 2012 NISSAN ALTIMA SEDAN code

Labor: 1.0

The cost to diagnose the P0037 2012 NISSAN ALTIMA SEDAN code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|When is the P0037 2012 NISSAN ALTIMA SEDAN code detected?

The P0037 is set when the ECM detects an excessively low voltage through the heated oxygen sensor heater circuit

|What are P0037 2012 NISSAN ALTIMA SEDAN code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|What is P0037 2012 NISSAN ALTIMA SEDAN code meaning?

Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).
In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.

|Need more information with the P0037 2012 NISSAN ALTIMA SEDAN code?

Need more information on how to fix the P0037 2012 NISSAN ALTIMA SEDAN code?
Get Access to Factory Service Manuals

|Need help with a P0037 2012 NISSAN ALTIMA SEDAN code?

Get the P0037 2012 Nissan Altima Sedan code diagnosed by a professional: Find a repair shop in your area