P0037 2008 NISSAN SENTRA - HO2S12 Heater Control Circuit Low
P0037 2008 NISSAN SENTRA Possible Causes
- Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 fuse
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 harness is open or shorted
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
First diagnose P0037 2008 NISSAN SENTRA code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.
P0037 2008 NISSAN SENTRA Tech NotesThe code means that there is a problem with the heater element circuit of the heated oxygen sensor. Water getting inside the heated oxygen sensor connector can caused the heated oxygen sensor fuse to blow, which is a very common problem for this type codes. Before replacing the sensor, check for the condition of the heated oxygen sensor fuse and connectors.
See more pictures on link below
2007-2012 Nissan Sentra Air/Fuel Ratio - Oxygen Sensor Location
Cost of diagnosing the P0037 2008 NISSAN SENTRA code
Labor: 1.0The cost of diagnosing the P0037 2008 NISSAN SENTRA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the P0037 2008 NISSAN SENTRA code detected?The P0037 is set when the ECM detects an excessively low voltage through the heated oxygen sensor heater circuit
P0037 2008 NISSAN SENTRA Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P0037 2008 NISSAN SENTRA MeaningOxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).
In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
P0037 2008 NISSAN SENTRA More InformationNeed more information on how to fix the P0037 2008 NISSAN SENTRA code?
Get Access to Factory Service Manuals