Engine-Codes
 
OBDII Code List
 
P0031 LAND-ROVER

P0031 LAND-ROVER - HO2S Heater Control Circuit Low Bank 1 Sensor 1

Repair Importance Level: 2/3
Repair Difficulty Level: 2/3  What does this mean?

P0031 LAND-ROVER Possible Causes

  • Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 harness is open shorted to ground
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit poor electrical connection
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit fuse
  • Faulty Engine Control Module (ECM)

First diagnose P0031 LAND-ROVER code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

P0031 LAND-ROVER Tech Notes

The code means that there is a problem with the heater element circuit of the heated oxygen sensor. Water getting inside the heated oxygen sensor connector can caused the heated oxygen sensor fuse to blow, which is a very common problem for this type codes. Before replacing the sensor, check for the condition of the heated oxygen sensor fuse and connectors.
HO2S Heater Control Circuit Low Bank 1 Sensor 1 is the generic definition for the P0031; however your vehicle's manufacturer may have a different definition and information for the P0031 code.

Cost of diagnosing the P0031 LAND-ROVER code

    Labor: 1.0

    The cost of diagnosing the P0031 LAND-ROVER code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

When is the P0031 LAND-ROVER code detected?

The P0031 is set when the ECM detects an excessively low voltage through the heated oxygen sensor heater circuit

P0031 LAND-ROVER Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P0031 LAND-ROVER Meaning

Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).

In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.

The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.

OBDII Code P0031 LAND-ROVER - HO2S Heater Control Circuit Low Bank 1 Sensor 1 - Engine-Codes.com

P0031 LAND-ROVER More Information

Need more information on how to fix the P0031 LAND-ROVER code?
Get Access to Factory Service Manuals

Related Information