P0031 2013 NISSAN ROGUE - Air Fuel Ratio Sensor 1 Heater Bank 1 Control Circuit Low
P0031 2013 NISSAN ROGUE Possible Causes
- Faulty Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 harness is open shorted to ground
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit poor electrical connection
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit fuse
- Faulty Engine Control Module (ECM)
First diagnose P0031 2013 NISSAN ROGUE code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.
P0031 2013 NISSAN ROGUE Tech Notesbefore replacing anything you can try to clear mixture ratio self-learning http://nissanhelp.com/diy/rogue/projects/nissan_rogue_clear_self_learning.php
Cost of diagnosing the P0031 2013 NISSAN ROGUE code
Labor: 1.0The cost of diagnosing the P0031 2013 NISSAN ROGUE code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the P0031 2013 NISSAN ROGUE code detected?The P0031 is set when the ECM detects an excessively low voltage through the heated oxygen sensor heater circuit
P0031 2013 NISSAN ROGUE Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P0031 2013 NISSAN ROGUE MeaningAir-Fuel Ratio (A/F)sensor need to reach a minimum operating temperature of 1200 degrees F to produce an accurate voltage signal. The faster the air-fuel ratio sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).
In order to achieve the require temperature, a heater element is included inside the air-fuel ratio sensor. The ECM controls the air-fuel ratio sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
P0031 2013 NISSAN ROGUE More InformationNeed more information on how to fix the P0031 2013 NISSAN ROGUE code?
Get Access to Factory Service Manuals