P0031 2009 NISSAN SENTRA Code - Air Fuel Ratio Sensor 1 Heater Bank 1 Control Circuit Low
|P0031 2009 NISSAN SENTRA code possible causes
- Faulty Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 harness is open shorted to ground
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit poor electrical connection
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit fuse
- Faulty Engine Control Module (ECM)
|How is the P0031 2009 NISSAN SENTRA code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|P0031 2009 NISSAN SENTRA code tech notesSee more pictures on link below 2007-2012 Nissan Sentra Air/Fuel Ratio - Oxygen Sensor Location
|What is the cost to diagnose the P0031 2009 NISSAN SENTRA code
Labor: 1.0The cost to diagnose the P0031 2009 NISSAN SENTRA code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|When is the P0031 2009 NISSAN SENTRA code detected?The P0031 is set when the ECM detects an excessively low voltage through the heated oxygen sensor heater circuit
|What are P0031 2009 NISSAN SENTRA code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
|What is P0031 2009 NISSAN SENTRA code meaning?Air-Fuel Ratio (A/F)sensor need to reach a minimum operating temperature of 1200 degrees F to produce an accurate voltage signal. The faster the air-fuel ratio sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).
In order to achieve the require temperature, a heater element is included inside the air-fuel ratio sensor. The ECM controls the air-fuel ratio sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
|Need more information with the P0031 2009 NISSAN SENTRA code?Need more information on how to fix the P0031 2009 NISSAN SENTRA code?
Get Access to Factory Service Manuals