P0029 HYUNDAI - Exhaust Valve Control Solenoid Circuit Range/Performance Bank 2
P0029 HYUNDAI Possible Causes
- Dirty engine oil
- Low engine oil level
- Faulty exhaust valve control solenoid
- Exhaust valve control solenoid harness is open or shorted
- Exhaust valve control solenoid circuit poor electrical connection
How is the P0029 HYUNDAI code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P0029 HYUNDAI code
Labor: 1.0The cost to diagnose the P0029 HYUNDAI code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?ECM monitors OCV stuck while cam signal is normally generating and Valve cleaning is not in progress.If the CAM Acutal Position is too high or low and Difference between Cam Actual Positionand Desired Position is higher than 20° ECM determines that a fault exists and the P0029 codes is set.
- Engine Light ON (or Service Engine Soon Warning Light)
P0029 HYUNDAI MeaningThe Continuously Variable Valve Timing (CVVT) system is installed to the chain sprocket of the exhaust camshaft. This system controls the exhaust camshaft to provide the optimal valve timing. The Engine Control Module (ECM) controls the Oil Control Valve(OCV), based on the signals output from mass air flow, throttle position and engine coolant temperature. The CVVT controller regulates the intake camshaft angle using oil pressure through the OCV. As result, the relative position between the camshaft and the crankshaft becomes optimal, and the engine torque improves, fuel economy improves, exhaust emissions decrease under overall driving conditions.
More InformationNeed more information on how to fix the P0029 HYUNDAI code?
Get Access to Factory Service Manuals