Engine-Codes - Suzuki - P0019 Suzuki

P0019 Suzuki Code - Crankshaft Position - Exhaust Camshaft Position Correlation Bank 2

- Code Popularity: 6,922 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0019 Suzuki?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • The correct installation of the camshaft sensors
  • The correct installation of the crankshaft sensor
  • A timing chain tensioner condition
  • An incorrectly installed timing chain
  • Excessive play in the timing chain
  • A timing chain that jumped teeth
⚠ Does your Suzuki have Safety Recalls? → Check here

How to Fix the DTC P0019 Suzuki?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0019 Suzuki Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0019 Suzuki code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P0019 Suzuki Code Mean?

The Camshaft Position (CMP) actuator system enables the Engine Control Module (ECM) to change the timing of the camshafts while the engine is operating. The CMP actuator solenoid signal from the ECM is Pulse Width Modulated (PWM). The ECM controls the CMP actuator solenoid duty cycle by controlling the amount of solenoid ON time. The CMP actuator solenoid controls the advance or the retard of each camshaft. The CMP actuator solenoid controls the oil flow that applies the pressure to advance or retard the camshafts.
Ignition voltage is supplied directly to the CMP actuator solenoid. The ECM controls the solenoid by grounding the control circuit with a solid-state device called a driver. The ECM compares the camshaft position or the camshaft angle, to the position of the crankshaft.
The Diagnostic Trouble Code (DTC) will set if the ECM detects a deviation in the relationship between a camshaft and the crankshaft.
P0019 Suzuki Code - Crankshaft Position - Exhaust Camshaft Position Correlation Bank 2

Need more Information on the Code?

Need more information on how to fix the P0019 Suzuki code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0019 Suzuki code diagnosed by a professional: Find a repair shop in your area