Engine-Codes - Ford - P0016 2008 Ford Fusion

P0016 2008 Ford Fusion Code - Crankshaft Position Camshaft Position Correlation Bank 1 Sensor 'A'

- Code Popularity: 8,763 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0016 2008 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Camshaft timing incorrectly set
  • Continuous oil flow to the Variable Camshaft Timing (VCT) piston chamber
  • Erratic camshaft position due to low oil pressure
  • Oil flow restriction in the oil passages or the VCT valve body
  • VCT solenoid stuck in position
  • Faulty Variable Camshaft Timing
  • Variable Camshaft Timing harness is open or shorted
  • Variable Camshaft Timing circuit poor electrical connection
  • Damaged camshaft position (CMP) sensor
  • Open or short in the CMP sensor circuits
  • Radio frequency interference (RFI) interference
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P0016 2008 Ford Fusion?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0016 2008 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0016 2008 Ford Fusion code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P0016 2008 Ford Fusion Code Mean?

This Diagnostic Trouble Code (DTC) sets when the Powertrain Control Module (PCM) detects Variable Camshaft Timing (VCT) position misalignment between the camshaft and crankshaft. The test fails when the misalignment is one tooth or greater. This DTC can also set due to VCT system concerns (oil contamination or VCT solenoid stuck).

P0016 2008 Ford Fusion Code - Crankshaft Position Camshaft Position Correlation Bank 1 Sensor 'A'

Need more Information on the Code?

Need more information on how to fix the P0016 2008 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0016 2008 Ford Fusion code diagnosed by a professional: Find a repair shop in your area