P0016 2005 KIA SORENTO - Crankshaft Position-Camshaft Position Correction- Bank 1 Sensor 'A'
P0016 2005 KIA SORENTO Possible Causes
- Faulty Crankshaft Position
- Crankshaft Position harness is open or shorted circuit.
- Crankshaft Position circuit poor electrical connector
- Faulty Camshaft Position
- Camshaft Position harness is open or shorted circuit.
- Camshaft Position circuit poor electrical connector
- Incorrect timing
- Engine mechanical problems
- Damaged Engine Control Module (ECM)
How do I fix code P0016 2005 KIA SORENTO?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Cost of diagnosing the P0016 2005 KIA SORENTO code
Labor: 1.0The cost of diagnosing the P0016 2005 KIA SORENTO code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?If the relative angle between CKPS and CMPS is out of the threshold value, the ECM determines that a fault exist and it set the P0016.
- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of power
- Engine rough idle
P0016 2005 KIA SORENTO MeaningThe Camshaft Position Sensor (CMPS) and the Crankshaft Position Sensor (CKPS) are hall effect type of sensors that generate voltage using a sensor and a target wheel. Then CMPS signal is sent to the Engine Control Module (ECM) and the ECM uses the its signal for synchronizing the firing of sequential fuel injectors. And the Crankshaft Position Sensor (CKPS) is sent to the ECM and it calculates engine RPM by using CKPS's signal and controls the injection duration and the ignition timing.
P0016 2005 KIA SORENTO More InformationNeed more information on how to fix the P0016 2005 KIA SORENTO code?
Get Access to Factory Service Manuals