Engine-Codes -
Saab -
P0014 SAAB
P0014 SAAB - Exhaust Camshaft Position System Performance
Table of contents
P0014 SAAB Possible Causes
- Dirty Oil
- Low engine oil level
- Faulty Exhaust Camshaft Position Actuator Solenoid
- Exhaust Camshaft Position Actuator Solenoid harness is open or shorted
- Exhaust Camshaft Position Actuator Solenoid circuit poor electrical connection
- Faulty Engine Control Module (ECM)
How is the P0014 SAAB code repair?
Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.Tech Notes
There is a factory service bulletin for the 2004-2009 Saab 97x:2004-2009 Saab 97x Factory Service Bulletin OBDII Code P0014
What is the cost to diagnose the P0014 SAAB code
Labor: 1.0
The cost to diagnose the P0014 SAAB code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P0014 SAAB Meaning
The Camshaft Position (CMP) actuator is attached to each camshaft and is hydraulically operated in order to change the angle of the camshaft relative to Crankshaft Position (CKP). The CMP actuator solenoid is controlled by the control module. The control module sends a pulse width modulated 12-volt signal to a CMP actuator solenoid. The solenoid controls the amount of engine oil flow to a CMP actuator. The CMP actuator can change the camshaft angle a maximum of 25 degrees. The control module increases the pulse width to accomplish the desired camshaft operation.More Information
Need more information on how to fix the P0014 SAAB code?Get Access to Factory Service Manuals