P0014 HUMMER - Exhaust Camshaft Position System Performance

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What does this mean?

P0014 Hummer Possible Causes

  • Dirty Oil
  • Low engine oil level
  • Faulty Exhaust Camshaft Position Actuator Solenoid
  • Exhaust Camshaft Position Actuator Solenoid harness is open or shorted
  • Exhaust Camshaft Position Actuator Solenoid circuit poor electrical connection
  • Faulty Engine Control Module (ECM)

P0014 Hummer Tech Notes

There is a factory service bulletin for the following Hummer models:

2004-2009 Hummer H3
2004-2009 Hummer H3 Factory Service Bulletin OBDII Code P0014

P0014 Hummer Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P0014 Hummer Meaning

The Camshaft Position (CMP) actuator is attached to each camshaft and is hydraulically operated in order to change the angle of the camshaft relative to Crankshaft Position (CKP). The CMP actuator solenoid is controlled by the control module. The control module sends a pulse width modulated 12-volt signal to a CMP actuator solenoid. The solenoid controls the amount of engine oil flow to a CMP actuator. The CMP actuator can change the camshaft angle a maximum of 25 degrees. The control module increases the pulse width to accomplish the desired camshaft operation.
OBDII Code P0014 Hummer - Exhaust Camshaft Position System Performance - Engine-Codes.com

Related Information