Engine-Codes - Audi - P0014 Audi

P0014 Audi Code - 'B' Camshaft Position Timing Over-Advanced Or System Performance Bank 1

- Code Popularity: 23,971 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0014 Audi?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Dirty engine oil
  • Mechanical Defect
  • Valve Timing
  • Faulty Continuously Variable Valve Timing Solenoid
  • Continuously Variable Valve Timing Solenoid harness is open or shorted
  • Continuously Variable Valve Timing Solenoid circuit poor electrical connection
⚠ Does your Audi have Safety Recalls? → Check here

How to Fix the DTC P0014 Audi?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0014 Audi Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0014 Audi code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

What Does the P0014 Audi Code Mean?

This fault code is stored in the Engine Control Module (ECM) when a malfunction occurs in the camshaft position sensor monitoring system. This fault code can be set due to a fault with the camshaft position sensor, phonic wheel, associated wiring or engine control module. A mechanical defect which affects static valve timing can also cause this issue. A variable valve timing defect must also be investigated, including oil supply to the oil control solenoid. The oil control solenoid should also be tested using an oscilloscope, the solenoid may be operated during an actuator test. A fault in the sprocket dephaser or variator will also cause this fault code to be set.
A relationship test with an oscilloscope can be used to check the valve timing. For vehicles with a phonic wheel which is attached to a keyless pulley it must be noted that the static valve timing maybe correct but the position of the phonic wheel is incorrect.

P0014 Audi Code - 'B' Camshaft Position Timing Over-Advanced Or System Performance Bank 1

Need more Information on the Code?

Need more information on how to fix the P0014 Audi code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0014 Audi code diagnosed by a professional: Find a repair shop in your area