P0011 HYUNDAI - 'A' Camshaft Position Timing Over-Advanced Or System Performance Bank 1
P0011 HYUNDAI Possible Causes
- Low or Dirty Engine Oil
- Faulty Valve Timing Control (VTC)
- Valve Timing Control (VTC) harness is open or shorted circuit.
- Valve Timing Control (VTC) circuit poor electrical connector
- Incorrect timing
- Engine mechanical problems
- Damaged Engine Control Module (ECM)
First diagnose P0011 HYUNDAI code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.
P0011 HYUNDAI Tech NotesThere is a factory service bulletin for the following Hyundai models:
2003-2006 SULEV Elantra (XD)
2004-2008 Tiburon 2.0L (GK)
Tucson 2.0L (JM)
Elantra Touring (FD)
Genesis Coupe (BK)
Santa Fe (CM)
Genesis Coupe (BK)
Genesis Sedan (BH)Genesis Sedan (BH)
The bulletin provides information on how to inspect and diagnose problems related to the Oil Control Valve (OCV) used in Constant Variable Valve Timing (CVVT), if at any time the OCV is suspected as the caused of rough idling, poor acceleration, camshaft timing misalignment-related trouble codes, misfire-related trouble codes.
Bulletin: Hyundai Constant Variable Valve Timing Oil Control Valve Inspection
Cost of diagnosing the P0011 HYUNDAI code
Labor: 1.0The cost of diagnosing the P0011 HYUNDAI code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
P0011 HYUNDAI Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of power
- Engine rough idle
P0011 HYUNDAI MeaningThe CVVT (Continuously Variable Valve Timing) system is installed to the chain sprocket of the exhaust camshaft. There is no variation in valve timing of the exhaust cam because the exhaust camshaft is driven by the timing belt. The timing of the intake cam is varied by the relative operation the CVVT vane to the housing. The CVVT controller regulates the intake camshaft angle using oil pressure through the OCV (Oil Control Valve). As result, the relative position between the camshaft and the crankshaft becomes optimal, and the engine torque improves, fuel economy improves, exhaust emissions decrease by changing the valve open/close timing of the intake camshaft.
The deviation of the camshaft position from the target point is evaluated during stable driving condition. The Engine Control Module (ECM) accumulates this deviation for a certain period and sets DTC P0011 when the accumulated deviation is too high. The target camshaft position is predetermined value depending on engine speed and throttle angle in the ECM.
P0011 HYUNDAI More InformationNeed more information on how to fix the P0011 HYUNDAI code?
Get Access to Factory Service Manuals