Engine-Codes - Nissan - P0011 2009 Nissan Rogue

P0011 2009 Nissan Rogue Code - Intake Valve Timing Control Performance Bank 1

- Code Popularity: 11,199 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
ChatAC AutoCodes.com AI Chat

What are the Possible Causes of the DTC P0011 2009 Nissan Rogue?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Low or Dirty Engine Oil
  • Faulty Intake Valve Timing Control Solenoid Valve
  • Intake Valve Timing Control Solenoid Valve harness is open or shorted
  • Intake Valve Timing Control Solenoid Valve circuit poor electrical connection
  • Faulty Camshaft Position Sensor
  • Camshaft Position Sensor harness is open or shorted
  • Camshaft Position Sensor circuit poor electrical connection
  • Faulty Crankshaft Position Sensor (POS)

Code Tech Notes

Since the Intake valve timing control solenoid valve uses oil flow to control timing, dirty oil can cause the valve to stuck open or close. Before replacing the valve, change engine oil and filter and reset engine code.

⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC P0011 2009 Nissan Rogue?

Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.

Search for P0011 2009 Nissan Rogue Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

The cost to diagnose the P0011 2009 Nissan Rogue code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.

When is the Code Detected?

When there is a gap between angle of target and phase-control angle degree, the valve will stop working and the ECM will trigger the P0011 code.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine Lack / Loss of Power
  • Engine Rough Idle

What Does the P0011 2009 Nissan Rogue Code Mean?

This mechanism hydraulically controls cam phases continuously with the fixed operating angle of the intake valve.
The ECM receives signals such as crankshaft position, camshaft position, engine speed, and engine coolant temperature. Then, the ECM sends ON/OFF pulse duty signals to the intake valve timing control solenoid valve depending on driving status. This makes it possible to control the shut/open timing of the intake valve to increase engine torque in low/mid speed range and output in high-speed range.
The intake valve timing control solenoid valve changes the oil amount and direction of flow through intake valve timing control unit or stops oil flow. The longer pulse width advances valve angle. The shorter pulse width retards valve angle. When ON and OFF pulse widths become equal, the solenoid valve stops oil pressure flow to fix the intake valve angle at the control position.

P0011 2009 Nissan Rogue Code - Intake Valve Timing Control Performance Bank 1

Need more Information on the Code?

Need more information on how to fix the P0011 2009 Nissan Rogue code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0011 2009 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area