P0010 MITSUBISHI - Intake Engine Oil Control Valve Circuit
P0010 MITSUBISHI Possible Causes
- Intake Engine Oil Control Valve circuit is open or shorted
- Intake Engine Oil Control Valve circuit poor electrical connection
- Faulty intake engine oil control valve
- Faulty Engine Control Module (ECM)
First diagnose P0010 MITSUBISHI code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.
Cost of diagnosing the P0010 MITSUBISHI code
Labor: 1.0The cost of diagnosing the P0010 MITSUBISHI code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
P0010 MITSUBISHI Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P0010 MITSUBISHI MeaningThe Camshaft Position (CMP) actuator is attached to each camshaft and is hydraulically operated in order to change the angle of the camshaft relative to Crankshaft Position (CKP). The CMP actuator solenoid is controlled by the control module. The control module sends a pulse width modulated 12-volt signal to a CMP actuator solenoid. The solenoid controls the amount of engine oil flow to a CMP actuator. The CMP actuator can change the camshaft angle a maximum of 25 degrees. The control module increases the pulse width to accomplish the desired camshaft operation.
P0010 MITSUBISHI More InformationNeed more information on how to fix the P0010 MITSUBISHI code?
Get Access to Factory Service Manuals