Engine-Codes - Land-rover - P0010 LAND-ROVER

P0010 LAND-ROVER - Intake Camshaft Position Actuator Solenoid Control Circuit

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3  What is this?
Table of contents

P0010 LAND-ROVER Possible Causes

  • Dirty Oil
  • Low engine oil level
  • Faulty Intake Camshaft Position Actuator Solenoid
  • Intake Camshaft Position Actuator Solenoid harness is open or shorted
  • Intake Camshaft Position Actuator Solenoid circuit poor electrical connection
  • Faulty Engine Control Module (ECM)

How is the P0010 LAND-ROVER code repair?

Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

What is the cost to diagnose the P0010 LAND-ROVER code

Labor: 1.0

The cost to diagnose the P0010 LAND-ROVER code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P0010 LAND-ROVER Meaning

The Camshaft Position (CMP) actuator is attached to each camshaft and is hydraulically operated in order to change the angle of the camshaft relative to Crankshaft Position (CKP). The CMP actuator solenoid is controlled by the control module. The control module sends a pulse width modulated 12-volt signal to a CMP actuator solenoid. The solenoid controls the amount of engine oil flow to a CMP actuator. The CMP actuator can change the camshaft angle a maximum of 25 degrees. The control module increases the pulse width to accomplish the desired camshaft operation.

More Information

Need more information on how to fix the P0010 LAND-ROVER code?
Get Access to Factory Service Manuals

Need more help?

Get the P0010 Land-rover code diagnosed by a professional: Find a repair shop in your area