This Diagnostic Trouble Code (DTC) may be accompanied by other DTCs. Diagnose all Camshaft Position (CMP) Sensor DTCs first. If no CMP sensor related DTCs are present, continue checking the Variable Camshaft Timing (VCT) Solenoid.
Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
The cost to diagnose the P0010 Ford code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
The Variable Camshaft Timing (VCT) solenoid valve is an integral part of the VCT system. The solenoid valve controls the flow of engine oil in the VCT actuator assembly. As the Powertrain Control Module (PCM) controls the duty cycle of the solenoid valve, oil pressure/flow advances or retards the cam timing. Duty cycles near 0% or 100% represent the rapid movement of the camshaft. Retaining a fixed camshaft position is accomplished by dithering (oscillating) the solenoid valve duty cycle.
The PCM calculates and determines the desired camshaft position. It continually updates the VCT solenoid duty cycle until the desired position is achieved. A difference between the desired and actual camshaft position represents a position error in the PCM VCT control loop. The PCM disables the VCT and places the camshaft in a default position if a concern is detected. A related Diagnostic Trouble Code (DTC) also sets when the concern is detected.
When the VCT solenoid is energized, engine oil is allowed to flow to the VCT actuator assembly which advances or retards the camshaft timing. One half of the VCT actuator is coupled to the camshaft and the other half is connected to the timing chain. Oil chambers between the 2 halves couple the camshaft to the timing chain. When the flow of oil is shifted from one side of the chamber to the other, the differential change in oil pressure forces the camshaft to rotate in either an advance or retard position depending on the oil flow.
This DTC sets when a low or high voltage on the VCT11 circuit is detected.
Need more information on how to fix the P0010 Ford code? Get Access to Factory Service Manuals
Get the P0010 Ford code diagnosed by a professional: Find a repair shop in your area