P0010 2009 TOYOTA CAMRY - Camshaft Position 'A' Actuator Circuit Bank 1
P0010 2009 TOYOTA CAMRY Possible Causes
- Dirty Oil
- Variable Valve Timing (VVT) circuit is open or shorted
- Oil Control Valve (OCV) circuit is open or shorted
- Faulty variable valve timing (VVT)
- Faulty oil control valve (OCV)
- Damaged ECM
How is the P0010 2009 TOYOTA CAMRY code repair?Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
What is the cost to diagnose the P0010 2009 TOYOTA CAMRY code
Labor: 1.0The cost to diagnose the P0010 2009 TOYOTA CAMRY code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?After the ECM sends the target duty cycle signal to the OCV, the ECM monitors the OCV current to establish an actual duty cycle. The ECM determines the existence of a malfunction and sets the DTC when the actual duty cycle ratio varies from the target duty cycle ratio.
- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of power
- Engine rough idle
P0010 2009 TOYOTA CAMRY MeaningThe Engine Control Module (ECM) controls the Oil Control Valve (OCV) to regulate the intake camshaft angle. As a result of the angle change, the engine timing is advance or retard. Optimizing engine timing will help the engine improve torque and fuel economy, and the exhaust emissions decrease under overall driving conditions. The Variable Valve Timing (VVT) system includes the Oil Control Valve (OCV) and VVT controller. The ECM detects the actual intake valve timing using signals from the camshaft and crankshaft position sensors, and performs feedback control.
More InformationNeed more information on how to fix the P0010 2009 TOYOTA CAMRY code?
Get Access to Factory Service Manuals