Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
The cost to diagnose the C1005 Fiat code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The Electronic Power Steering (EPS) system employs a column-mounted electric power steering unit along with a manual steering rack and pinion to provide a variable power-assisted steering with reduced parasitic engine load. The EPS controller monitors two steering wheel position sensors to determine the absolute position of the steering shaft and determines driver input via a steering wheel torque sensor. In addition, the EPS controller uses four hall-effect position sensors to monitor the absolute and commanded position of the motor. The EPS controller obtains vehicle speed, alternator output, and steering mode information, and broadcasts warning lamp status and service diagnostic information, on CAN C. During normal driving, as the driver turns the wheel, the torque sensor value changes based on the effort the driver uses to turn the wheel. The controller uses this information, along with the steering wheel absolute position and vehicle speed, to determine the amount torque required from the motor. Voltage is then provided to the motor to provide power steering assist. If the Body Control Module (BCM) detects an EPS status lamp failure, this C1005 code will set.
Need more information on how to fix the C1005 Fiat code? Get Access to Factory Service Manuals
Get the C1005 Fiat code diagnosed by a professional: Find a repair shop in your area