C0277:06 Brake Pedal Position Sensor Circuit Low Voltage/Open
C0277:07 Brake Pedal Position Sensor Circuit High Voltage
C0277:09 Brake Pedal Position Sensor Circuit Too Fast Transitions
C0277:12 Brake Pedal Position Sensor Circuit Below Minimum Threshold
C0277:4B Brake Pedal Position Sensor Circuit Calibration Not Learned
Check the 'Possible Causes' listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector pins.
The cost to diagnose the C0277 Hummer code is 1.0 hour of labor. The diagnosis time and labor rates at auto repair shops vary depending on the location, make and model of the vehicle, and even the engine type. Most auto repair shops charge between $75 and $150 per hour.
The brake pedal position sensor is used to sense the action of the driver's application of the brake pedal. The brake pedal position sensor provides an analog voltage signal that will increase as the brake pedal is applied. The Body Control Module (BCM) provides a low reference signal and a 5 V reference voltage to the brake pedal position sensor. When the variable signal reaches a voltage threshold indicating the brakes have been applied, the BCM will apply battery voltage to the left and right stop lamp control circuits as well as the center high-mounted stop lamp relay control circuit illuminating the left and right stop lamps and the center high mounted stop lamp. The Diagnostic Trouble Code (DTC) will be set when the BCM detects an improper voltage in the brake pedal position sensor 5 V reference circuit.
Need more information on how to fix the C0277 Hummer code? Get Access to Factory Service Manuals
Get the C0277 Hummer code diagnosed by a professional: Find a repair shop in your area