Start by checking the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
The cost to diagnose the B2294 Jaguar code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
The Restraints Control Module (RCM) continuously monitors the driver and passenger safety canopy module circuits (loop) for an acceptable resistance range, unacceptable voltage and shorts to ground. The RCM will set on-demand and store DTC B2294 in memory if any of these conditions are detected to be outside of their respectful range. If the RCM detects a fault, it will send a message to the instrument cluster module to illuminate the air bag warning indicator.
As the RCM continuously monitors safety canopy module circuits for resistance, it expects a normal resistance between 1.31 to 4.29 ohms.
If a loop resistance is between 0.9 and 1.31 or between 4.29 and 5 ohms, there exists a strong potential for an intermittent fault, a DTC may or may not set. The RCM will also set an on-demand DTC if the loop resistance is less than 0.9 ohm or greater than 5 ohms.
Need more information on how to fix the B2294 Jaguar code? Get Access to Factory Service Manuals
Get the B2294 Jaguar code diagnosed by a professional: Find a repair shop in your area